TF5 Yamaha Digital Console

Hanya Tersisa 5 lagi


Whatsapp admin

Deskripsi

  • 33 motor faders (32 channels + 1 master)
  • 48 input mixing channels (40 mono + 2 stereo + 2 return)
  • 20 Aux (8 mono + 6 stereo) + Stereo + Sub buses
  • 8 DCA groups with Roll-out
  • 32 analog XLR/TRS combo mic/line inputs + 2 analog RCA pin stereo line inputs
  • 16 analog XLR outputs
  • 34 x 34 digital record/playback channels via USB 2.0 + 2 x 2 via a USB storage device
  • 1 expansion slot for NY64-D audio interface card

Outline

Fader Configuration32 + 1 (Master)
Mixing CapacityInput Channels48 (40 mono + 2 stereo + 2 return)
Aux Buses20 (8 mono + 6 stereo)
Stereo Buses1
Sub Buses1
Input channel functions8 DCA Groups
I/OInputs32 mic/line (XLR/TRS combo) + 2 stereo line (RCA pin)
Outputs16 (XLR)
Expansion slots1
On-board processorsDSP8 Effects + 10 GEQ
USB34x34 USB Audio Interface, 2-track recording via USB Storage Device

General specifications

Sampling frequency rateInternal48 kHz
Signal delayLess than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz
Fader100 mm motorized, Resolution = 10-bit, +10 dB to –138 dB, –∞ dB all faders
Total harmonic distortionLess than 0.05% 20 Hz–20 kHz @+4 dBu into 600 , INPUT to OMNI OUT, Input Gain=Min. (Measured with a –18 dB/octave filter@80 kHz)
Frequency response+0.5, –1.5 dB 20 Hz–20 kHz, refer to +4 dBu output @1kHz, INPUT to OMNI OUT
Dynamic range110 dB typ., DA Converter, 107 dB typ., INPUT to OMNI OUT, Input Gain=Min.
Hum & noise levelEquivalent input noise–128 dBu typ., Input Gain=Max. (Measured with an A-Weight filter)
Residual output noise–85 dBu, ST master off (Measured with an A-Weight filter)
Crosstalk–100 dB (Measured with a –30 dB/octave filter@22 kHz), adjacent INPUT/OMNI OUT channels, Input Gain=Min.
Power requirements100–240 V 50/60 Hz
Power consumption120 W
DimensionsW866 mm (34.1in)
H225 mm (8.9in)
D599 mm (23.6in)
Net weight20.0 kg (44.1lb)
AccessoriesQuick Guide, Power Cord, CUBASE AI download information
OptionsExpansion Card, Foot Switch (FC5)
OthersOperating temperature range: 0–40 °C, Storage temperature range: -20–60 °C

Analog input characteristics

Input TerminalsGAINLoad
Impedance
For Use With
Nominal
Input LevelConnectorbalanced /
Unbalanced
Sensitivity*1NominalMax. before clip
INPUT1-32+66dB7.5KΩ
50-600Ω Mics
or 600Ω Lines
-82dBu (61.6V)-62dBu (0.616mV)-42dBu (6.16mV)Combo Jack (XLR-3-31 type *2
or TRS phone *3)
Balanced
-6dB-10dBu (245mV)+10dBu (2.45V)+30dBu (24.5V)
ST IN 1,210kΩ600Ω Lines-30dBV (31.6V)-10dBV (316mV)+10dBV (3.16V)RCA Pin JackUnbalanced

*1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*In these specifications, 0dBu = 0.775Vrms.
*+48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.

Analog output characteristics

Output TerminalsSource
Impedance
For Use With
Nominal
GAIN SWOutput LevelConnectorbalanced /
Unbalanced
NominalMax. before clip
OMNI OUT 1-1675Ω600Ω Lines
“+24dBu” position (default)

+4dBu (1.23 V)+24dBu (12.3 V)XLR-3-32 type *1Balanced
PHONES *3100Ω40Ω Phones3mW75mWStereo Phone Jack (TRS) *2Unbalanced

*1.1: GND,2: HOT, 3: COLD 
*2 Tip: LEFT, Ring: RIGHT, Sleeve: GND 
*3 The position of the level control is lowered by 16dB from the maximum.
*In these specifications, 0dBu = 0.775Vrms. 
*All output DA converters are 24bit, 128times oversampling.

Digital input/output specifications

TerminalsFormatData lengthAudioConnector
USB (TO HOST)USB24bit34ch input / 34ch output, PCMUSB (B type)
iPadUSBPlayback: MP3 or WAV file data / Record: WAV file data
USB (A type)

 

Control I/O specifications

TerminalsFormatLevelConnector
NETWORKIEEE802.310BASE-T/100Base-TXRJ-45
FOOT SWTS Phone

 

Top